Need Help Trouble Shooting - DNCB 276 stopped cooling
#1
Posted 28 June 2009 - 02:31 PM
The compressor is still humming, all fans are still running, the condenser is hot, the evaporator coils are not cold, the accumulator is not cold. the small diameter copper wire tube and coil is hot.
Hopefully that is enough information to get started with trouble shooting tips, ask more questions or point me in the right direction. BTW, I went to the Dixie Narco web site and the primary manual on-line excluded the troubleshooting section.
Many Thanks
-Kevin
#2
Posted 28 June 2009 - 09:48 PM
It needs some FreOn in it,I need your help. I have an older DNCB 276 machine that stopped cooling.
The compressor is still humming, all fans are still running, the condenser is hot, the evaporator coils are not cold, the accumulator is not cold. the small diameter copper wire tube and coil is hot.
Hopefully that is enough information to get started with trouble shooting tips, ask more questions or point me in the right direction. BTW, I went to the Dixie Narco web site and the primary manual on-line excluded the troubleshooting section.
Many Thanks
-Kevin
#3
Posted 30 June 2009 - 03:02 PM
Thanks
-Kevin
#4
Posted 30 June 2009 - 05:27 PM
try www.vendingworld.com they are located in californiaThanks for the input Ronald. It turns out that my condenser fan motor must start to be going bad. It had stopped and I was able to manually rotate it and the moter took over and it is currently running with cold sodas. I am sure this is probably temporary, so I am going to look into buying a new fan motor. Can anyone give me a recommendation of a low cost supplier for these older Dixie Narco machines?
Thanks
-Kevin
#5
Posted 01 July 2009 - 05:25 AM
try www.vendingworld.com they are located in california
Thanks Snack Dude










