One of my snack machines a usi 3014a display stopped working if u turn machine off an back on it works for a couple of seconds on shuts off machine still functions just no display anyone ran into this ?
3 replies to this topic
#2
Ronald
-
- Members
-
- 37 posts
Advanced Member
- Gender:Male
- Location:Arkansas
Posted 08 November 2010 - 10:37 PM
You can try unplugging all wire on computer board and plugging them back in has worked for me.
#3
RJT
-
- Members
-
- 367 posts
Advanced Member
- Gender:Male
Posted 10 November 2010 - 04:12 PM
This could be either a control board or just the digital read out itself. I had one doing the same thing but it would stay on for about 30 sec and then go blank. I changed the digital read out but it was the board itself.
These are both fairly expensive items. Used and working control board can run over $100 and a digital read out can run around $80. They can be rebuilt and it will run you aroumnd the same price.
These are both fairly expensive items. Used and working control board can run over $100 and a digital read out can run around $80. They can be rebuilt and it will run you aroumnd the same price.
#4
dondon
-
- Members
-
- 16 posts
Member
Posted 12 November 2010 - 06:12 PM
Rjt was right I took the display board to another 3014a I had plunged it in it worked like a charm following day main controlling board went no matter such selection u choose it would only bend from a1 ,thanks everyone for there input
