There are two selections in my Dixie Narco 501E that make two complete rotations when vending, in the process three cans fall out. All the other selections work fine. The cam is set properly on the correct number. One of the "cradles", where the cans sit in, stops in a half-moon position instead of ending face up to allow the sodas to fall inside.
Any suggestions?
1 reply to this topic
#1
Qmancandy
-
- Members
-
- 23 posts
Member
- Gender:Male
- Location:Orlando, FL
- Interests:I've been in business since 06/2005. I have added soda machines, combo and snack machines. I have some bulk vending and spiral gumball machines as well.
Posted 13 April 2011 - 09:35 PM
#2
vendtech101
-
- Members
-
- 9 posts
Newbie
- Gender:Male
Posted 15 May 2011 - 01:23 PM
There are two selections in my Dixie Narco 501E that make two complete rotations when vending, in the process three cans fall out. All the other selections work fine. The cam is set properly on the correct number. One of the "cradles", where the cans sit in, stops in a half-moon position instead of ending face up to allow the sodas to fall inside.
Any suggestions?
Does the cam switch stop in the valley? If it does then remove the brown cam and make a 180 degree turn with the cam and reinstall it to the motor. Sounds like some one has the bail out 180 degree's, then shut the door and it should home back to the correct position. Use the other columns as a reference.
vendtech101...
