Validator problem on DN 368
#1
Posted 19 December 2012 - 11:09 PM
I have pulled it apart the best I can in the machine. Everything appears to be normal and nothing is in it or blocking any paths that I can tell. It runs briefly (startup) after plugging it back in and then the error codes start blinking.
Curious if anyone has any suggestions... or is it just toast and should I go ahead and replace it?
#2
Posted 20 December 2012 - 11:07 AM
#3
Posted 20 December 2012 - 12:40 PM
I might have a 2501 to throw in its place... Do you know off the top of your head if I can just swap out the faceplates on those and be good to go?
#4
Posted 21 December 2012 - 09:22 AM
The machine has a Mars VN-2511 validator in it. Currently the LED is blinking 5 times over and over which I realize means the magazine is removed... but it is actually on. I can take it on and off, makes no difference in the error. If I unplug the validator and plug it back in, it will blink 4 times (cross channel blocked) once, then it goes to blinking 5 times over and over.
I have pulled it apart the best I can in the machine. Everything appears to be normal and nothing is in it or blocking any paths that I can tell. It runs briefly (startup) after plugging it back in and then the error codes start blinking.
Curious if anyone has any suggestions... or is it just toast and should I go ahead and replace it?
#5
Posted 21 December 2012 - 09:32 PM
It's a single price machine... It doesn't have a door button that I have been able to locate.Did you try pushing and holding the door button to see if the light stays on?
#6
Posted 24 January 2013 - 08:12 AM
#7
Posted 25 January 2013 - 09:44 PM
#8
Posted 10 February 2013 - 12:11 PM