Coinco Changer ?
#1
Posted 10 September 2008 - 06:21 AM
Thanks
JD
#2
Posted 10 September 2008 - 06:51 AM
#3
Posted 14 September 2008 - 06:50 PM
not knowing the changer model nor the machine model they are on.... i may suggest that a lot of the newer equipment requires a "tube fill"... check the manual on the equipment piece and it should show you how to do it... basically by going into machine mode and scrolling totube fill you then feed your change thru the "head of the changer" (not the tubes) until you get to the level you desire.. then exiting mode to standby/ready. from then on if everything is working properly it should refill to your prescribed level...
Jeremiah, if the quarters run out - or at least if they get low enough that the bill validator disables - then it would seem like the float sensor may be bad in the quarter tube. I had this problem recently, and it was a bad float sensor.
#4
Posted 14 September 2008 - 07:49 PM
Before sending it off for repair, you may want to pull the front of the coin tube cover off and clean the sensors good. Sometimes over time the dirt from the coins will cover the sensors with a film of dirt and give the impression of a full tube. It fixes the problem more times than not and doesn't cost anything. Its worth a try and Good luck.Jeremiah, if the quarters run out - or at least if they get low enough that the bill validator disables - then it would seem like the float sensor may be bad in the quarter tube. I had this problem recently, and it was a bad float sensor.