3 replies to this topic

[gascap21]

I am wondering if any dollar bill validator would fit on it.

[ronsidney]

You need to check the voltage..if the little tag on the wire going to it says 12v or 117v.. more than likely it is a mars (MEI) and you can probably just get it fixed from the local distributor...dont plug a 12v bill validator into a 110v harness even if its exactly the same size plug (because they are!! dumb i know)

what brand is it? if its a 110v ICT then he Mars 110v will plug in exactly the same..

do you operate alot of amusements machines??

I operate cranes, amusements , bulk and pushers.. I also manufacture my own pushers.

I love to chat about all this stuff and I've been full time for about 15 years.

thanks
ronsidney
blazingquarters.com

[rduv]

rons is right - and check it with your ohm meter (just in case power is the problem). Do you know what the problem with the old validator is?

[gascap21]

I don't own another machines. There was never a bill validator on it. I bought it without one. I seen it is a 12v but I can't find a bill validator that is 12v there all 110v or 24v