I have a Coinco BA30B validator. I'm having a problem with the Stacker. It will accept and stack the first dollar bill just fine. But the Stacker Plate will not end it's cycle at the proper home position. It will push the first bill in, return to it's home position and push a second time. When pushing the second time, the plate will then stop mid-way through it's second push when the plate is at its fullest extended point and stop there. The next bill inserted (which it still will accept bills) will then get jammed behind the stacker plate.
Pushing the coin return button will reverse the bill, but will not change the status of the stacker plates position. The problem is pretty consistent and I have only been able to clear the problem by manually and gently pushing the Stacker Plate back to the home position. But then the same problem will happen from the beginning with the next dollar bill.
I do get an error code of 5 blink (bill jam or sensor error), but only after the second bill jams behind the stacker plate.
Any thoughts?
Thank you in advance,
DVS