To all,
I am hoping someone can help.
We acquired a PolyVend 6632M - 2931 4-wide snack machine.
It has a CoinCo 12 pin, 24v mech.
It is missing the DBV.
The harness for the DBV is the same that would fit a Mars VFM series 110v dbv, but that dbv is too tall to fit.
The mounting for the dbv is via brackets: one on the bottom, one on (what would be the top) the top of the dbv.
Question: Could someone with a PV6632M please tell us what DBV and harness they are using? Any and all info would be greatly apprecitated.
Matt
PolyVend help needed
Started by mjc, Sep 24 2008 12:33 PM
2 replies to this topic
#1
Posted 24 September 2008 - 12:33 PM
#2
Posted 28 September 2008 - 08:31 PM
i know but not telling you haha sucker
Cokeman, don't be a jerk. If you can't be gracious enough to give an answer that you know, then don't post a smart-___ remark.
#3
Posted 29 September 2008 - 11:04 AM
I looked at this guy's other posts and he posted the same assinine response several other times in other topics. I am reporting him to the forum master and asked that he be kicked out.