Hello again...still trying to help some local club members with a Coke Vendo drink machine (Model 324185024 971117, Serial # 599847). Original 117v Mag bill acceptor would only take a bill in half way. Replaced with two other 117v units and they did the same thing even though they were properly functioning reconditioned acceptors. Then put in a 24v Ardac with the same result. Also replaced coin mech to see if that was a problem but the result was the same. Does this mean there is a problem with the control board? Any other ideas? Thanks!

Vic

Hello...I have a USI 3038 with a bad vending mechanism. I have several motors from 3061 machines...mechanisms look the same but 3061 has a 4-pin plug and 3038 plug is 2-pin...can the 3061 mechanism be adapted to the 3038? If not, any suggestions would be appreciated. Tried Wittern Tech Support but no answers there. Thanks!

Vic

Hello again...trying to help local club set up a six selection Vendo Coke machine (Model 324185024 971117, Serial # 599847). Thought would use three button programming like my other machines but apparently does not. I get an error code when entering the service mode. That is followed by these codes...in no particular order: CPO, Chgr (I think), and IC (input chute). I also got the message that there are no errors when pursuing error codes a time or two...I can't get to Prc...don't know how to clear error code(s). The manual does not include programming info.

From info I have, it looks like this machine is programmed using four selection buttons.  Any info would be most helpful. Everything else seems to work fine...bills and change register, it gives change, and all six selections vend.