Jump to content

Close

Mustang

Member Since 17 Aug 2011
Offline Last Active Apr 01 2013 10:27 PM
-----

Topics I've Started

Dn 276 damaging the cans

11 March 2013 - 08:58 PM

I have a rotor with a metal tab that is damaged and sticking straight out. I don't know if this is a spring or what? It is causing the cans to break open when they drop into the rotor. Do I need to replace the rotor or can I just remove the damaged tap. I just don't know how important this piece is.
Thanks for any help

Raising soda prices on customers

06 February 2013 - 10:30 PM

I just purchased a few soda accounts and most of the machines are priced at 55 or 60 cents and I want to raise the price to 75. I don't want to piss off the new accounts I just picked up so is there a good way to go about doing this? Should I wait a few months to raise the price or slowly increase 5 cents every few months?
Thanks for the advise

T handle lock pops open

23 January 2013 - 02:57 PM

I have a couple of machines where the t handle will pop out if I wiggle the lock or handle. Is this an issue with the plug lock or the t handle. The plug lock looks and functions normal as far as I can tell. Just not sure if I purchase a cheap lock or do I need to replace the t handle.

Thanks
  1. Vendingchat.com - All Vending Forums and Bulletin Board
  2. → Viewing Profile: Topics: Mustang
  3. Privacy Policy
  4. User Rules & Guidelines ·