2 replies to this topic

[Regent Repair Service]

Have a USI 3014A will not read any motors.  Pricing works and mech and validator are new and tested again to make sure are good.  The bank said there was a power surge and then it said exact change only.  Have checked all wire connections and repriced all selections....

[AZVendor]

If your machine won't vend (you don't say what happens when you put money in and try to select something) then you probably have a bad logic board.  While you can set prices does the machine accept coins and/or bills and what does the display then show?  Do you get correct change back if you press the coin return?  Try that after dropping in one of each coin, then try it with a dollar bill.  What then happens when you try to make a selection?

[Regent Repair Service]

It says exact change but when you make a selection to see the price displayed, it just says make other selection it also gives me all zeros when I do a motor count.  I just replaced this board a year ago for this customer.  I have been doing this for about 20 years and never had it say there were no motors...But yes I was thinking the same thing was the board but just wanted some others insight....I even erased all the pricing and redid it all.  But no will not accept coins or bills.