2 replies to this topic

[ultimatevend]

Hello everyone I have just purchased a Vendo 600-E Soda machine. I found out the hard way that you cant just put cans in this machine and expect it to work. It was set up for 20oz bottles, so I have since added the rods & shims needed for cans. My problem is that I cant get it to dispense one can at a time, it lets out three at a time or none at all. I set the cam setting for #1 position as writtin on the door of the machine and I have the rod position in the B slot and still trouble. I did get one of the selections to vend one can at a time and this has me baffled because I set them all up the same. One vendor told me that somtimes the clip that hits the cam as it goes around could be bent and its not catching also I have the cans three deep as shown on the diagram on the machine. Any help from some one that is very familar with these machines would be very appreciated thanks.

[Andros 1337]

Hello everyone I have just purchased a Vendo 600-E Soda machine. I found out the hard way that you cant just put cans in this machine and expect it to work. It was set up for 20oz bottles, so I have since added the rods & shims needed for cans. My problem is that I cant get it to dispense one can at a time, it lets out three at a time or none at all. I set the cam setting for #1 position as writtin on the door of the machine and I have the rod position in the B slot and still trouble. I did get one of the selections to vend one can at a time and this has me baffled because I set them all up the same. One vendor told me that somtimes the clip that hits the cam as it goes around could be bent and its not catching also I have the cans three deep as shown on the diagram on the machine. Any help from some one that is very familar with these machines would be very appreciated thanks.

I've never heard of a Vendo 600E. Are you sure you don't mean the Dixie-Narco 600E?

[ultimatevend]

Yes my mistake I got it figured out, all the first set of cams were reversed probem solved