You need to make sure that the rod is removed and that you have the 20 oz bottle shim in there. The can shim has one 90 degree angle while the 20 oz is much skinnier and has 2 90 degree angles. once that is done make sure you adjust the brown cam setting, if the lable is still attatched to the inside of the machine it should illustrate this. Good luck!!!
I got it to work, I had the rods in the correct hole in the back but not the one in the front. They are all working and good now, thanks a lot. By the way how can i set up a column to work for poland spring 16.9 oz?
I set up all the columns the same way. Cam set to #1, rod in position B or the middle hole and I installed the 12 oz shims. two of the columns work, when three sodas come out i hear the roter restock itself for the forth. the other columns seem that they are not turning enough because it will not vend then vend twice then vend once then it starts the cycle again (0,2,1,0,2,1......
Hey thanks for the tip, I replaced all the comumns with the correct shims and placed the rod in the middle hole. Two columns now vend correctly, however two others kept giving problems. all the cams are set to #1 so I dont know what else it coul be. Any ideas???
I use a milk crate. I put any leftover cans in there or when I use my car I pull only what I need and fill up the milk crates. You can find them outside supermarkets at night, sneak over and grab a few.
Find content
Not Telling
