Jump to content

Close

gvending

Member Since 29 Jun 2008
Offline Last Active Oct 25 2011 07:25 PM
-----

Topics I've Started

Dixie Narco

21 August 2010 - 12:32 PM

I have Dixie Narco 8 selection machine. For some reason selection 4 and 5 are out of service. Whats seemed to happened is that the micro- arms on both motors are stuck at the same spot and are not finding their "home" positions. It seems strange that this would happen to both motors right next to each other at the same time. This would make me think that it is a problem with the board and not the motors? Does this seem right? Or, is there another explaination that I could be missing?

Thanks for the help,

Justin

Dixie 501 T Single Price

05 April 2010 - 11:16 AM

Hello,

I have a Dixie 501T single price machine. It seems like on this machine the coin mech acts as the control board. Can I upgrade this machine by putting in an SIID board? How would I do it. At the very least I imagine I'd have to buy new harnesses and make changes to the coin mech? I really have no idea though. Can anyone give me an idea of what I would have to do?

Thanks,

Justin

Nixie Narco Compressor Problem

09 January 2010 - 11:32 AM

Hello,

I have a Dixie Narco 501 can vendor that is not cooling. When I turn the thermostat on so that the compressor should start I hear a buzzing sound followed by a popping sound like the compressor is shorting out. Then, this proccess starts over again about thirty seconds later.

Does this mean I have to replace the whole compressor or is there just a fuse or starter that I can replace? I am fairly new to vending so any advice from you seasoned guys would be apprecatied.

Thanks,

Justin
  1. Vendingchat.com - All Vending Forums and Bulletin Board
  2. → Viewing Profile: Topics: gvending
  3. Privacy Policy
  4. User Rules & Guidelines ·