Hi vending people...I have a National 145 with a maka bill acceptor factory setting where the logic board is attached above the acceptor on the door....My question is will another manufacturer fit in this narrow area....Or should I just get the maka repaired...I still have two of these 145 machines.....

I need some advise on the bev max 2145 is $1600 a good price....should i get a newer one...

1. Are tall gates and the latest pushers found on the bev max 2145 if not
will it cost a lot to do. I read about this in another ad.

2. I see ECC or Dixie Narco are they the same.

3. Should I consider an arm unit like bev max 3. I just think i want
to keep it simple and service calls to minimum.

4. I need a machine that has variety and a small foot print and one
that i can service from the front. Also are they like a snack machine
in the fact that the filling trays pull out..

5. Do all bev max gravity have those 3 holes at the delivery and some i have seen
have a push decal. Does that mean an older model.

I have a d/n 368 and the bottles are getting caught half way across the bottle...Once they get cold they seem to be a lot more flimsy than before even with the new design. I use crystal geyser on the middle 5 and 6 column.. Any ideas....