Jump to content

Close

Joven76

Member Since 01 Jun 2007
Offline Last Active Feb 13 2012 05:08 PM
-----

Posts I've Made

In Topic: Changing from one bill acceptor to another

14 June 2011 - 06:47 PM

That looks like the right one, however it doesn't appear to be long enough from the picture... I'll have to contact them to see how long it is..

In Topic: Changing from one bill acceptor to another

14 June 2011 - 05:37 AM

I'm looking for the main MDB harness that comes from the board and connects to the Y harness... I'll give the Vendor Exchange a call...

Thanks for the info!!!

In Topic: Changing from one bill acceptor to another

13 June 2011 - 07:44 PM

Ok, another question concerning the same kind of machine... On a completely different machine, I'm now getting a "No Link" error which means the MDB cable that runs from the PC board to the coin mech isn't being recognized... I've tested it on a different machine, and I get the same error, so I'm lead to believe it's a bad cable... Is there anyplace I can go to get this cable from other than the manufacturer... They're a little on the extreme expensive side when it comes to spare parts and was hoping I could find it someplace else...

Any suggestions???

In Topic: Changing from one bill acceptor to another

22 April 2011 - 02:01 PM

Thanks for the info!

In Topic: Changing from one bill acceptor to another

22 April 2011 - 01:43 PM

But is the bill changer I have an MDB unit... I've been told no, so I would have to buy a whole new bill validator...
  1. Vendingchat.com - All Vending Forums and Bulletin Board
  2. → Viewing Profile: Posts: Joven76
  3. Privacy Policy
  4. User Rules & Guidelines ·